Do not charge with non-rechargeable batteries.Always use, replace, and recharge (if applicable) batteries under adult supervision. Insert batteries using the correct polarity.Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.If the product appears worn, frayed/splintered, cracked, or broken in any manner, discontinue use and discard immediately. Thoroughly inspect products before every use.Adult supervision is recommended when operating the vehicle.Do not leave vehicle or transmitter near sources of heat or under direct sunlight for long periods of time.Keep fingers, hair and loose clothing away from wheels while vehicle is in motion.Never operate your vehicle in in climate weather, rain, or standing water.Do not use people or animals as obstacles.When the Burnout Drifter water tank is empty, the rear wheel red LED will flash during burnout to let you know you need to add more water.Please leave enough room (approximately 20 feet) in front of the vehicle. The vehicle will automatically accelerate forward with smoke effect. To perform a burnout, make sure the vehicle is stationary, then press the burnout mode button on the top left of the remote.Press the drift mode button again to exit drift mode. Push the throttle up and turn right or left to drift with smoke effect. The remote light will flash showing the vehicle is in Drift Mode. For a drifting turn, press the drift mode button on the top right of the remote.For normal turning, push the throttle up to go forward and the turning stick to the left or right depending on what direction you want to turn.The steering controls left and right turning. The throttle controls forward and reverse. Control the vehicle using the remote-control sticks.To turn the vehicle off, press and hold the power button on the bottom of the vehicle for 3 seconds. Turn the power knob on the remote clockwise and push the power button on the bottom of the vehicle to switch on.Carefully remove items from the package.Reclose the gasket and slide the reservoir door closed.Wipe any excess water with a dry clean towel. Gently squeeze the tank to dispense the water. Slowly fill the tank using the water container until full.Open the PVC gasket by gently pulling on the tab.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |